Toyotomi Toyostove Laser 730 Assembly, Installation And Operation Instructions page 29

Laser 730&AT_Type A_US.qxd 15.3.18 16:36 ページ 29
6. Insert the bent joint to the exhaust opening of the flue pipe. Cut the inlet hose for desired length if necessary.
Attach the L-shaped hose to each end of the inlet hose and attach the L-shaped hose to the intake opening of
the flue pipe. Secure the L-shaped hose to the intake opening with the hose band. Plug the unused exhaust
(metal cap) and intake (rubber cap) opening with the caps provided with the heater. Make sure the caps fit
tightly onto the opening (See Fig. 10).
Inlet Hose
L-Shaped Hose
NOTE: If the inlet hose is not smoothly inserted into the L-shaped hose, apply water with soap suds to the
inlet hose. Do not use grease on air intake.
7. Move the heater into position. Connect the bent joint to the exhaust outlet opening (upper opening) and at-
tach the L-shaped hose to the intake inlet opening. Make sure all connections are tight (See Fig. 11).
Hose Band
Exhaust Air Cap
(metal)
Outlet Opening
Inlet Opening
Exhaust Opening
Bent Joint
Fig. 10
Bent Joint
L-Shaped Hose
Fig. 11
Intake Air Cap
(rubber)
29