Bracelet Designs; Stuffed Doll Designs - ELNA Creative Series Instruction Book

q
z
q

Bracelet Designs

You can make a your own bracelet by sewing the bracelet
designs on a water soluble stabilizer.
Use the same thread for the bobbin as the needle thread.
Use a fully wound bobbin.
Set the low bobbin thread warning level to 3 or 4 (refer to
page 57).
Set the maximum sewing speed to 600 spm or less (refer
to page 57).
Set the water soluble stabilizer in the hoop.
Be sure that the stabilizer is stretched tightly in the hoop.
Select the desired bracelet design pattern and sew.
Remove the water soluble stabilizer from the hoop.
Trim away the water soluble stabilizer surrounding the
design pattern with scissors.
Remove the water soluble stabilizer by soaking the
bracelet design into the bowl of warm water.
Attach the chain rings* to the each end of the bracelet.
q Chain ring
q
* Chain rings are not included with the machine.

Stuffed Doll Designs

You can make your own stuffed doll with the In-The-Hoop
Designs. Prepare the following materials.
• Fabric 1 (18˝ x 12˝: 46 x 30 cm)
• Fabric 2 (16˝ x 10˝: 41 x 25 cm)
• Stabilizer (non-water-soluble)
• Wad cotton
* You can attach parts like horns to stuffed dolls of
designs RE36b-8 and 9. Prepare fabric of your desired
design and material.
Press the hoop selection key to select the RE36b.
Select the design from no.7 to no.9.
Example: RE36b-8 + horns
z Attach a stabilizer on the wrong side of the fabric 1
and set the fabric in the embroidery hoop RE36b (refer
to pages 18, 20-21).
Place the extra wide table on the machine (refer to
page 6).
Attach the embroidery hoop on the carriage (refer to
page 22).
q Fabric 1
w
w Stabilizer
NOTE:
Do not remove the fabric from the embroidery hoop
until the sewing project is finished.
50