Note: Remove the film that covers the thermal pad (if any) when installing the M.2 solid-state drive and the
heat sink.
Front I/O bracket
Prerequisite
Before you start, read Generic Safety and Compliance Notices, and print the following instructions.
Before you open the computer cover, turn off the computer and wait several minutes until the computer is
cool.
For access, do the following:
1. Turn off the computer and remove all connected devices and cables.
2. Remove the computer cover. See "Computer cover" on page 50.
3. Remove the front bezel. See "Front bezel" on page 51.
.
Chapter 6
Hardware removal and installation
61