Replacing The Front I/O Bracket, Power Button And The Card Reader - Lenovo ideacentre 510S Series Hardware Maintenance Manual

Step 11. Remove the seven screws that secure the motherboard to the chassis.
1
7
Step 12. Slide then lift the motherboard out of the chassis to remove it.
Step 13. Install the new motherboard:
a. Line up the holes on the new motherboard with mounting holes on the chassis and secure
it with screws.
b. Reattach the memory module, Wi-Fi card and the heat-sink assembly to the new motherboard.
c. Connect the all cables to the new motherboard.
d. Attach the graphic card to the new motherboard.
Step 14. Reattach the front bezel and the computer cover.

Replacing the front I/O bracket, power button and the card reader

Note: For this procedure, it helps to lay the computer flat.
To replace the the front I/O bracket, power button or the card reader.
Step 1. Remove any media (disks, CDs, DVDs, or memory cards) from the drives, shut down the operating
system, and turn off the computer and all attached devices.
Step 2. Unplug all power cords from electrical outlets.
Step 3. Disconnect all cables attached to the computer. This includes power cords, input/output (I/O)
cables, and any other cables that are connected to the computer. Refer to "Left and right view"
and "Rear view" for help with locating the various connectors.
Step 4. Remove the computer cover. Refer to "Removing the computer cover".
Step 5. Remove the front bezel. Refer to "Removing the front bezel".
Step 6. Follow the below illustration to replace the front I/O bracket, power button or card reader.
2 3
4
6
5
.
Chapter 8 Replacing hardware
37