Table of Contents
Advertisement
Care and Cleaning
„ Titanium apatite photocatalytic air-purifying filter
1.
Take off the titanium
apatite photocatalytic air-
purifying filters.
• Open the upper front panel and pull out the air filters.
• Hold the recessed parts of the frame and unhook
the 4 claws.
Claw
2.
Clean or replace the titanium
apatite photocatalytic air-
purifying filters.
[Cleaning]
2-1 Vacuum dust, and soak in lukewarm
water or water for about 10 to
15 minutes if very dirty.
• Do not remove the filter from the frame when
washing with water.
2-2 After washing, shake off remaining
water and let them dry in the shade.
• Do not wring out the filter to remove water from it.
[Replacement]
Remove the filter from the filter
frame and attach a new one.
• Do not throw away the filter frame. Reuse the
filter frame when replacing the titanium apatite
photocatalytic air-purifying filter.
• When attaching the filter, check that the filter is
properly set in the tabs.
• Dispose of the old filter as non-flammable waste.
33
Tabs
3.
Set the filters as they were and
close the upper front panel.
• Return the panel support plate to its previous position.
• Lower the lower front panel to the original position.
• Close the upper front panel slowly.
• Press the upper front panel at both sides.
NOTE
• Operation with dirty filters:
– cannot deodorise the air,
– cannot clean the air,
– results in poor heating or cooling,
– may cause odour.
• Dispose of old filters as non-flammable waste.
• To order titanium apatite photocatalytic air-purifying
filter, contact the dealer where you bought the air
conditioner.
Titanium apatite photocatalytic
Item
air-purifying filter (without frame) 1 set
Part No.
KAF970A46
Advertisement
Table of Contents
