Elation KL FRENSEL 6 User Manual page 8

S A F E T Y I N S T R U C T I O N S A N D G U I D E L I N E S
DO NOT TOUCH
approximately 15 minutes for the fixture to cool down before serving.
DO NOT
shake fixture, avoid brute force when installing and/or operating fixture.
DO NOT
operate fixture if the power cord has become frayed, crimped, damaged
and/or if any of the power cord connectors are damaged and do not insert into the
fixture securely with ease.
power cord or any of its connectors are damaged, replace it immediately with a new one
of similar power rating.
DO NOT
block any air ventilation slots. All fan and air inlets must remain clean and
never blocked. Allow approx. 6" (15cm) between fixture and other devices or a wall for
proper cooling.
When installing fixture in a suspended environment, always use mounting hardware that
is no less than M10 x 25 mm, and always install fixture with an appropriately rated
safety cable.
Always disconnect fixture from main power source before performing any type of
service and/or cleaning procedure. Only handle the power cord by the plug end, never
pull out the plug by tugging the wire portion of the cord.
During the initial operation of this fixture, a light smoke or smell may emit from the
interior of the fixture. This is a normal process and is caused by excess paint in the
interior of the casing burning off from the heat associated with the lamp and will
decrease gradually over time.
Consistent operational breaks will ensure fixture will function properly for many years.
ONLY
use the original packaging and materials to transport fixture in for service.
www.elationlighting.com
the fixture housing during operation. Turn OFF the power and allow
NEVER
force a power cord connector into the fixture. If the
8