Sharp MX-C528F User Manual page 115

Use printer menus
Menu item
Toner patch sensor setup
Print TPS information page
Scanner Configuration
Scanner Manual Registration
Print Quick Test
Scanner Configuration
Scanner Manual Registration
Front ADF Registration
Rear ADF Registration
Flatbed Registration
Scanner Configuration
Reset Maintenance Counter
Scanner Configuration
Edge Erase
Flatbed Edge Erase (3*)
ADF Edge Erase (3*)
Scanner Configuration
ADF Deskew
ADF Electronic Deskew (On*)
Scanner Configuration
Disable Scanner
No*
Yes
ADF Only
Scanner Configuration
Tiff Byte Order
CPU Endianness*
Little Endian
Big Endian
Scanner Configuration
Exact Tiff Rows Per Strip
On*
Off
Note: An asterisk (*) next to a value indicates the factory default setting.
Description
Print a diagnostic page that contains information on toner patch
sensor calibration.
Print a Quick Test target page.
Note: Make sure that the margin spacing on the target page
is uniform all the way around the target. If it is not, then the
printer margins must be reset.
Manually register the flatbed and ADF after replacing the ADF,
scanner glass, or controller board.
Reset the counter after replacing the ADF maintenance kit.
Set the size, in millimeters, of the no‑print area around an ADF
or flatbed scan job.
Reduce skewing of documents that are scanned from the ADF.
Disable the scanner when it is not working properly.
Set the byte order of a TIFF‑formatted scan output.
Set the RowsPerStrip tag value of a TIFF‑formatted scan output.
115