Table of Contents
Advertisement
16.5 To replace the burner.
(See figure 26).
1. Remove the burner unit (See section 16.2).
2. Support the elbow injector and unscrew the injector
nut.
3. Remove the two screws from the burner clamping
plate (See figure 26)
4. Lift the right hand side of the burner, slide it to the
right and lift clear
5. Refit in reverse order.
16.6 To remove the main burner injector.
(See figure 27).
1. Remove the burner (See section 16.5).
2. Remove the burner clamping screw (See figure 27)
3. Unscrew the injector from the burner
4. Refit in the reverse order.
16.7 To remove the appliance from the fireplace.
1. Remove the burner unit (See section 16.2).
2. Slacken the hexagonal adjusters on the cable retainers
and unscrew the thumbscrews to release the cables (See
section 9.1 of installation instructions).
3. Refit as described in the relevant
installation sections. Make sure gas
soundness, sealing, spillage test and
performance are satisfactory.
16.8 To remove the fascia.
1. Remove the bottom front cover.
2. The fascia is made up of three trims.
These trims are held in place by magnets.
Remove the top trim by pulling forward.
Place carefully aside (See figure 28).
3. Remove the side trims by pulling forward.
Place carefully aside (See figure 28).
4. Refit in the reverse order. Make sure that
the top corners of the fascia have no gaps.
INSTALLER GUIDE
Page 27
Figure 26. Removal of burner
Figure 27. Main burner
Injector removal
Figure 28. Removal of fascia
Advertisement
Table of Contents
