Floor Sealing - Baxi 746 Installer's Manual

INSTALLER GUIDE
so that it is sealed against the fireplace front
surround.
8. Fit a cable retainer over the bottom end of
each cable.
9. Pull each cable taut. Push the cable retainers
hard up against the back panel. The end of the
cable adjuster will pass into the hole. Tighten
the screws in the retainers so that they clamp the
cables in position. Apply tension to the cables
by turning the hexagonal adjusters by hand (See
figure 16).
10. Inspect the installation of the hotbox against
the fireplace surround. If the hotbox is aligned
squarely and the sealing is satisfactory, fully
tighten the cable retainers.
11. If the hotbox is not correctly aligned, release
the tension on the cables by slackening the
screws and turning the hexagonal adjusters fully
anticlockwise. The hotbox should then
automatically realign itself. Pull each cable taut
Figure 16. Lower cable retention
again and push the cable retainers back against
the back panel. Again, tighten the screws in the
retainers and apply tension to the cables by turning
the hexagonal adjusters clockwise as far as
possible.
12. Do not cut off any excess cable, instead coil up
the cable so that they are available to allow easy
removal and refitting of the appliance during
subsequent service calls.
9.2

Floor sealing.

Using the floor sealing tape supplied, seal the
bottom of the hotbox to the fireplace and hearth
Figure 17. Floor sealing
floor. Run the tape over the centre bracket (See
figure17).
Page 18