Table of Contents
Advertisement
16.3 To remove the pilot unit.
1. Remove the burner unit (See section 16.2).
2. If lying the burner on its back, ensure that the work
surface is suitably protected This will avoid damage to
the work surface.
3. Detach the pilot pipe from the pilot unit.
4. Detach the thermocouple from the gas valve
5. Detach the electrode lead from the underside of the
electrode tab.
6. Remove the two screws securing the pilot unit (See
figure 24).
7. Refit in the reverse order.
Note:
1.
a whole assembly. Its individual components are not separately replaceable.
16.4 To remove the gas valve.
(See figure 25).
1. Remove the burner unit (See
section 16.2).
2. If lying the burner on its back,
ensure that the work surface is
suitably protected. This will avoid
damage to the work surface.Turn the
burner unit upside down. Detach the
thermocouple from the tap.
3. Detach the pilot pipe from the tap.
4. Detach the inlet pipe.
5. Detach the injector pipe
6. Detach the electrode lead from the
base of the electrode
7. Remove the control knob by pulling forward.
8. Remove the thermocouple by unscrewing the thermocouple nut at the gas valve.
9. Remove the hexagonal nut securing the gas valve to the mounting bracket.
10. Remove the gas valve
11. Refit in the reverse order.
INSTALLER GUIDE
The pilot unit is an atmosphere sensing device. It must be replaced as
Figure 25. Gas valve (Viewed from rear
with burner turned over)
Page 26
Figure 24. Pilot unit removal
Advertisement
Table of Contents
