Yamaha WOLVERINE 2015 Owner's Manual page 46

Pushing the "SELECT" button switches the
display between the odometer mode "ODO"
and the tripmeter modes "TRIP A" and "TRIP
B" in the following order:
ODO → TRIP A → TRIP B → ODO
To reset a tripmeter, select it by pushing the
"SELECT" button, and then push the "RE-
4
SET" button for at least three seconds. The
tripmeters can be used to estimate the dis-
tance that can be traveled with a full tank of
fuel. This information enables you to plan fu-
ture fuel stops.
TIP
To switch the display between "mph" and
"km/h", turn the key to "
and hold the "SELECT" button while turning
the key to " " (on).
" (off), then push
4-7
Clock, hour meter and voltage display
modes
1
2
3
1. "SELECT" button
2. "RESET" button
3. "CLOCK" button
4. Clock/Hour meter/Voltage display
Pushing the "CLOCK" button switches the
display between the clock mode "CLOCK",
the hour meter mode "HOUR", and the volt-
age display mode "
der:
CLOCK → HOUR →
4
" in the following or-
→ CLOCK