Yamaha WOLVERINE 2015 Owner's Manual page 144

Tightening torque:
Coolant drain bolt:
8 Nm (0.8 m·kgf, 5.8 ft·lbf)
12. Connect the coolant reservoir hose.
13. Pour the recommended coolant into the
radiator until it is full.
14. Pour the recommended coolant into the
reservoir to the maximum level mark, and
then install the reservoir cap.
ECB02190
NOTICE
Mix antifreeze with distilled water only.
However, if distilled water is not available,
8
soft water may be used for refilling. Do not
use hard water or salt water since they are
harmful to the engine.
Antifreeze/water mixture ratio:
1:1
Recommended antifreeze:
High-quality ethylene glycol antifreeze con-
taining corrosion inhibitors for aluminum
engines
Coolant quantity:
Radiator (including all routes):
2.85 L (3.01 US qt, 2.51 Imp.qt)
Coolant reservoir (up to the maximum level
mark):
0.28 L (0.30 US qt, 0.25 Imp.qt)
15. Remove the right panel and right rear
panel. (See page 8-11 for right panel and
right rear panel removal and installation
procedures.)
16. Loosen the water pump air bleed bolt,
without removing it, to allow all of the air
to escape from the air bleed bolt hole.
8-29