Table of Contents
Advertisement
Locate the Reed Switch (113) and the Magnet
(112) on the left side of the Pulley (49). Turn the
Pulley until the Magnet is aligned with the Reed
Switch. Make sure that the gap between the
Magnet and the Reed Switch is about 1/8 in. (3
mm). If necessary, loosen the #8 x 3/4" Tek Screw
(14), move the Reed Switch slightly, and then
retighten the Tek Screw. Reattach the Motor Hood
(not shown) with the #8 x 3/4" Screws (not shown)
and run the treadmill for a few minutes to check for
a correct speed reading.
Top
View
113
14
1/8 in.
SYMPTOM: The incline of the treadmill does not
change correctly
a. Calibrate the treadmill's incline system (see step 4
on page 27).
SYMPTOM: The walking belt slows when walked on
a. If an extension cord is needed, use only a 3-conduc-
tor, 14-gauge (1 mm
ft. (1.5 m).
b. If the walking belt is overtightened, treadmill per-
formance may decrease and the walking belt may
become damaged. Remove the key and UNPLUG
THE POWER CORD. Using the hex key, turn both
idler roller screws counterclockwise, 1/4 of a turn.
When the walking belt is properly tightened, you
should be able to lift each edge of the walking belt
2 to 3 in. (5 to 7 cm) off the walking platform. Be
careful to keep the walking belt centered. Then,
plug in the power cord, insert the key, and run the
49
treadmill for a few minutes. Repeat until the walk-
ing belt is properly tightened.
112
c. Your treadmill features a walking belt coated with
high-performance lubricant. IMPORTANT: Never
apply silicone spray or other substances to
the walking belt or the walking platform unless
instructed to do so by an authorized service
representative. Such substances may deterio-
rate the walking belt and cause excessive wear.
If you suspect that the walking belt needs more
lubricant, see the front cover of this manual.
d. If the walking belt still slows when walked on, see
the front cover of this manual.
31
) cord that is no longer than 5
2
b
2–3 in.
Idler Roller Screws
Advertisement
Table of Contents
