Table of Contents
Advertisement
Non-pyrolytic underbench ovens and side open door oven
Your underbench oven looks best when the control panel is
directly under the benchtop. An upper infill panel may have
to be added if the cooktop placed above the benchtop is too
deep.
Refer to cooktop installation instructions for required
clearance between cooktop and oven.
WVE612 models come with 10A power cord for 'Plug & Play'.
10A powerpoint is needed.
1.5m electrical service
cord
(models WVE612 only)
Pyrolytic underbench oven
Your underbench oven looks best when the control panel is directly under the benchtop. An upper infill panel may have
to be added if the cooktop placed over the oven is too deep. Refer to cooktop installation instructions for required
clearance between cooktop and oven.
Power point connection for the WVEP618 must be accessible with the appliance fully installed. If the supply cord is
damaged it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid
a hazard.
WARNING
CAUTION
NOTE: Dimension "D".
A requirement for all pyrolytic clean ovens – for proper ventilation there must be a gap at the bottom rear of the
cabinet. This can be a full width opening 20mm deep.
upper infill
(if required)
C
upper infill
(if required)
A
B
561
D
use black
installation
screws supplied
Flush fit
600
Proud fit
565
A
B
C
use black
installation
screws supplied
GAS TYPE
A
Flush fit
600
Proud fit
565
mounting
holes
596
A
B
600
581min
590
560 min
NOTE: If a powerpoint
is fitted it must be
accessible with the
appliance installed.
561
596
B
C
600
581min
590
560min
INSTALLING YOUR APPLIANCE
C
mounting
holes
D
20
20
7
Hide quick links:
Advertisement
Table of Contents
