Westinghouse WVE612 User Manual page 28

USING YOUR OVEN (CONTINUED)
Before first use
Initial cleaning
Remove all accessories and removable shelf supports
from the oven.
Refer to "Care and cleaning" chapter.
Clean the oven and the accessories before first use. After
cleaning, put the accessories and the removable shelf
supports back to their initial position.
First connection
When you connect the oven to the mains or after the
power is cut, you have to set the display contrast, the
display brightness and the time of the day.
1. Press or
2. Press OK to confirm
Setting the water hardness for WVEP618 model
The table below shows the water hardness range (dH)
with the corresponding Calcium deposit and the quality
of the water. Contact your local water supplier to set the
water hardness level or as an alternate set the default
value at level 4 (Water hardness function is in Basic
Settings menu). If the water hardness exceeds the values
in the table, fill the water drawer with bottled water.
Water
hardness
Class dH
1 0-7
2 7-14
3 14-21
4 over 21 over 3.8
Preheating before first use
New appliances can have an odour during first use. It is
recommended to 'run in' the oven before cooking for the
28
USING YOUR OVEN
to set the value
Calcium Calcium
Water
deposit deposit
classification
(mmol/l) (mg/l)
0-1.3 0-50 Soft
Moderately
1.3-2.5 50-100
hard
2.5-3.8 100-150 Hard
over 150 Very hard
first time. Operate the oven(s), empty. Set the function to
"Fan Bake" at a temperature of 180°C for approximately
30 minutes.
Please ensure that the room is well ventilated during this
process.
Daily Use
Navigating the menus
1. Turn on the oven
2. Press or to select the menu option
3. Press OK to move to the submenu or accept the
setting
At each point you can go back to the main menu
TIPS & INFORMATION
with