Checking The Brake Discs - KTM 125 Duke 2018 Owner's Manual

13 BRAKE SYSTEM
13.2
130

Checking the brake discs

Warning
Danger of accidents Worn-out brake discs reduce the braking effect.
–
Make sure that worn-out brake discs are replaced immediately. (Your authorized KTM workshop will
be glad to help.)
ulating the brake pressure. The control function causes a slight
pulsing of the hand and foot brake levers.
3
The ABS indicator lamp must light up after the ignition is
switched on and go out after starting off. If it does not go out after
starting off or if it lights up while riding, this indicates a fault in
the ABS system. In this case, the ABS is no longer enabled and
the wheels may lock during braking. The brake system itself stays
functional; only ABS control is not available.
The ABS indicator lamp may also light up if the rotating speeds of
the front and rear wheels differ greatly under extreme riding con-
ditions, for example when making "wheelies" or if the rear wheel
spins. This causes the ABS to switch off.
To reactivate the ABS, stop the vehicle and switch off the ignition.
The ABS is reactivated when the vehicle is switched on again. The
ABS indicator lamp goes out when you start off.