Polaris RANGER XP 1000 2021 Owner's Manual page 58

FEATURES AND CONTROLS
SEAT BELT INSPECTION
Inspect all seat belts for proper operation before each use of the vehicle.
1. Push the latch plate into the buckle until it clicks. The latch plate must slide
smoothly into the buckle. A click indicates that it's securely latched.
2. Push the red release latch in the middle of the buckle to make sure it
releases freely.
3. Pull each seat belt completely out and inspect the full length for any damage,
including cuts, wear, fraying or stiffness. If any damage is found, or if the seat
belt does not operate properly, have the seat belt system checked and/or
replaced by an authorized dealer.
4. To clean dirt or debris from the seat belts, sponge the straps with mild soap
and water. Do not use bleach, dye or household detergents. Rinse the entire
length of the belt webbing. Use a garden hose to flush out the retractor and
latch housings regularly.
SEAT AND STORAGE COMPARTMENTS
The electrical compartment is located under the center rear-most seat. Never
use this area for storage. Storage compartments are located under all other
seats. Remove the storage bin under the center rear-most seat to access the
battery and electrical compartment.
Always make sure all seats are properly installed before operating.
DRIVER'S SEAT
To access the storage area under the driver's seat, reach behind the driver's
seat and pull up on the latch. Roll the bottom of the seat forward toward steering
wheel.
PASSENGER'S SEAT
To access the storage area under the passenger seat, lift up on the front of the
passenger seat and raise it to the upright position.
ELECTRONIC POWER STEERING
(IF EQUIPPED)
Electronic power steering (EPS) engages when the ignition key is turned to the
ON position. EPS remains engaged whether the vehicle is moving or idle. To
conserve battery power, the EPS will shut down 5 minutes after the engine is
stopped if the key remains in the ON position. The EPS warning indicator will
illuminate to indicate the EPS has shut down. Turn the key off and on to reset
the unit. If the light remains on after starting the engine, the EPS system is
inoperative. See your POLARIS dealer, or other qualified person, as soon as
possible for repair. Continued operation could result in permanent damage to the
EPS unit and increased steering effort.
56