Polaris RANGER XP 1000 2021 Owner's Manual page 120

MAINTENANCE
4. Place a drain pan under the engine crankcase and remove the drain plug.
Allow the oil to drain completely.
5. Remove all cargo from the cargo box.
Always remove all cargo from the cargo box before lifting the box to access the
6. Pull up on the cargo box release lever to tilt the box.
7. Using the Oil Filter Wrench, turn the oil filter
it.
8. Using a clean dry cloth, clean the filter sealing surface on the engine
crankcase.
9. Lubricate the O-ring on the new oil filter with a film of fresh engine oil. Check
to make sure the O-ring is in good condition. Install it to specification.
Turn by hand until filter O-ring contacts sealing surface, then turn an
10. Replace the sealing washer on drain plug.
The sealing surface on the drain plug should be clean and free of burrs, nicks
11. Reinstall the engine crankcase drain plug. Torque drain plug to specification.
12. Remove oil fill cap. Fill engine with recommended engine oil.
13. Verify the transmission is still in PARK.
14. Start the engine and allow it to idle for 30 seconds.
15. Stop the engine and inspect for oil leaks. Wait at least 15 seconds before
removing the dipstick.
118
CAUTION
engine.
TORQUE
Oil Filter
additional 3/4 turn.
NOTICE
or scratches.
TORQUE
Crankcase Drain Plug
12 ft-lbs (16 Nm)
w
counter-clockwise to remove