Sennheiser MD 421-II - Microphone Manual

Sennheiser MD 421-II - Microphone Manual

Also See for MD 421-II:

Advertisement

Sennheiser MD 421-II - Microphone Manual

OPERATION

OPERATION

Important safety instructions

  1. Read these safety instructions and the instruction manual of the product.
  2. Keep these safety instructions and the instruction manual of the product. Always include all instructions when passing the product on to third parties.
  3. Only use attachments, accessories and spare parts specified by the manufacturer.

  4. The protective basket and pop shield must be completely dry when you mount them on the microphone. Moisture can cause malfunctions or damage to the capsule
  5. Do not attempt to open the product housing on your own. The warranty is voided for products opened by the customer.
  6. Refer all servicing to qualified service personnel. Servicing is required when the product has been damaged in any way, liquid has been spilled or objects have fallen into the product, when the product has been exposed to rain or moisture, does not operate normally, or has been dropped.
  7. Use the product only under the conditions of use listed in the specifications.
  8. Do not operate the product if it was damaged during transportation.
  9. Always run cables so that no one can trip over them.
  10. Keep the product and its connections away from liquids and electrically conductive objects that are not necessary for operating the product.
  11. Do not use any solvents or aggressive cleaning agents to clean the product.

  12. Very high signal levels can damage your hearing and your loudspeakers. Reduce the volume on the connected audio devices before switching on the product; this will also help prevent acoustic feedback.
  13. Always maintain a distance of at least 3.94" (10 cm) between the product and the cardiac pacemaker or implanted defibrillator (ICDs) or other implants since the product generate a permanent magnetic field.

Intended use

The product is designed for indoor and outdoor use.

The product can be used for commercial purposes.

It is considered improper use when the product is used for any application not named in the corresponding instruction manual.

Sennheiser does not accept liability for damage arising from improper use or misuse of this product and its attachments/accessories.

Before putting the products into operation, please observe the respective country-specific regulations!

SPECIFICATIONS

Frequency response 30 – 17,000 Hz
Transducer principle pressure gradient transducer
Pick-up pattern cardioid
Max. rejection at 180° 18 – 2 dB
Free-field open-circuit sensitivity 2 mV/Pa (= -54 dBV) ±2.5 d B
Electrical impedance 200 Ω
Min. terminating impedance 200 Ω
Insentivity to magnetic field at 50 Hz < 5 µV / 5 µT
Dimensions 215 x 46 x 49 mm
Weight approx. 385 g
Connector XLR-3

SPECIFICATIONS

POLAR PATTERN

POLAR PATTERN

FREQUENCY RESPONSE

FREQUENCY RESPONSE

Sennheiser electronic GmbH & Co. KG
Am Labor 1, 30900 Wedemark, Germany
www.sennheiser.com

Documents / Resources

References

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Sennheiser MD 421-II - Microphone Manual

Advertisement

Need Assistance?

Do you have a question about the MD 421-II that isn't answered in the manual? Leave your question here.

Error while submitting your question. Please, reload page and try again.

Thank you! Your question has been received!

Table of Contents