Filter Installation - Wells WVU96 Owner's Manual

Ventless universal hood system for electric cooking appliances
Hide thumbs Also See for WVU96:
Table of Contents

Advertisement

INSTALLATION
NOTE:
The BAFFLE FILTERS,
PRE-FILTERS and FILTER
PACK actuate position
switches when they are
properly positioned. They
must be properly installed
for the under hood cooking
appliance contactor to be
energized.
WARNING
SLIP AND FALL
HAZARD
DO NOT operate any
grease-producing cooking
appliance
(e.g. fryer or griddle) unless
the grease cup is properly
installed. Oil will drip onto floor
creating a slipping
hazard.
CAUTION
BURN HAZARD
DO NOT operate any
cooking appliance unless the
grease cup is installed.
Moisture dripping onto hot
surfaces, oil or grease can
cause splattering.
WARNINIG: Do not add
moisture during cooking.
Note: Adding moisture
during the cooking process
may cause pre-filter to lose
structural integrity.

FILTER INSTALLATION

Note air flow direction arrow on filter pack. Remove old filter pack
and slide new filter pack fully into the appropriate slot. Verify that
the airflow arrow points toward the fan.
PREFILTER HOUSING MUST
HOOK IN FLANGE AT TOP.
CHECK TO MAKE SURE YOU
CANNOT PUSH IT BACK
AFTER INSTALLATION
BAFFLE FILTER
PART NO. 2I-Z14670
Baffle filters are reusable and should be cleaned at least weekly.
Change pre-filters and smoke/odor filter pack as indicated on the front
panel. These filters are disposable and cannot be reused. The smoke
/ odor filter pack is accessed thru the front service door.
Pre-filters are located behind the baffle filters, when installing pre-filters
engage top retaining flange prior to seating pre-filter housing in lower
chamber.
Use only genuine Wells replacement parts and filters,
call (800) 264-7827 your authorized Wells service agent or our
authorized parts supplier Partstown. Parts supplied by others will void
your warranty and may not provide safe operation.
BAFFLE FILTER and GREASE CUP INSTALLATION
1.
Install baffle filter from front. Engage the baffle filter in the retainer
slot. Push up until the baffle filter bottom clears the lower lip of the
retainer, then lower the baffle filter into the bottom retainer
2.
Install GREASE CUP into brackets below the baffle filter.
Note: Failure to install the GREASE CUP will allow grease and
moisture from the BAFFLE FILTER to drop into hot cooking surfaces,
creating both a SAFETY HAZARD (hot oil splatter) and a HEALTH
HAZARD (contamination of the cooking surface or cooking oil).
16
25.9 Min
Clearance
SMOKE & ODOR
FILTER PACK
PART NO. WL0171
PREFILTER
PART NO. 2I-302579
AIRFLOW
SIDE VIEW
IL2377b

Advertisement

Table of Contents
loading

Table of Contents