Samsung WD9 T Series Manual page 27

Problem
Stops.
Fills with the wrong
water temperature.
Load is wet at the end
of a cycle.
Leaks water.
U-PJT_COMBO-AD_SimpleUX_MANUAL_DC68-04198A-04_EN.indd 27
• Plug the power cord into a live electrical outlet.
• Check the fuse or reset the circuit breaker.
• Close the door and tap
washing machine will not tumble or spin unless the door is closed.
• Before the washing machine starts to fill, it will make a series of clicking noises to
check the door lock and will do quick drain.
• There may be a pause or soak period in the cycle. Wait briefly, and the washing
machine may start.
• Make sure the mesh filter of the water supply hose at the water taps is not clogged.
Periodically clean the mesh filter.
• If the washing machine is not supplied with sufficient power, the washing machine
will temporarily not drain or spin. As soon as the washing machine regains
sufficient power, it will operate normally.
• Fully open both taps.
• Make sure the temperature selection is correct.
• Make sure the hoses are connected to the correct taps. Flush water lines.
• Make sure the water heater is set to supply a minimum of 49 °C hot water at the
tap. Also, check the water heater capacity and recovery rate.
• Disconnect the hoses and clean the mesh filter. The mesh filter may be clogged.
• While the washing machine fills, the water temperature may change as the
automatic temperature control feature checks incoming water temperature. This
is normal.
• While the washing machine fills, you may notice just hot and/or just cold water
going through the dispenser when cold or warm temperatures are selected. This
is a normal function of the automatic temperature control feature as the washing
machine determines the water temperature.
• Use the High or Extra High spin speed.
• Use high efficiency (HE) detergent to reduce oversudsing.
• Load is too small. Small loads (one or two items) may become unbalanced and not
spin completely.
• Make sure the drain hose is not kinked or clogged.
• Make sure the door is properly closed.
• Make sure all hose connections are tight.
• Make sure the end of the drain hose is correctly inserted and secured to the drain
system.
• Avoid overloading.
• Use high efficiency (HE) detergent to prevent oversudsing.
• Check the drain hose.
‐ Make sure the end of the drain hose is not placed on the floor.
‐ Make sure the drain hose is not clogged.
Action
to start the washing machine. For your safety, the
English 27
2022/7/11 9:47:36