Samsung WD9 T Series Manual page 21

System Functions
Tap and hold for 3 seconds to enter the system functions menu to change the following options.
Water Hardness
Calibration
• Alarm: You can turn on or off the melody of cycle completion. However, the other sounds stay active.
• Smart Control: Turn on Smart Control to enable control of your appliance.
AddWash (applicable models only)
To add laundry after the wash starts, use the AddWash door.
1. Tap to stop the wash cycle.
2. Press the upper area of the AddWash door to unlock the door. The door will move inward slightly when you press
it and then will open.
3. Open the AddWash door fully, and then insert additional laundry through the AddWash door into the drum.
4. Lift the AddWash door back into position, and then lock the door by pushing the upper area of the door until you
hear a click. Then, tap
NOTE
The water inside the drum does not leak if the AddWash door is closed properly. Water drops may form around the
AddWash door, but water will not leak from inside the drum. This is normal.
The AddWash door does not open and the "AddWash door is open" message appears.
This message appears if you attempt to open the AddWash door while the machine is operating. The machine senses
the AddWash door is slightly open and stops operating for safety reasons.
If this happens, close the AddWash door, and then tap
When can't I open the AddWash door?
You cannot open the AddWash door:
• When the internal temperature is higher than 50 °C.
• During a drum-cleaning cycle such as Drum Clean+. These cycles do not have laundry inside the drum.
CAUTION
Do not try to open the AddWash door while the drying or boiling process is running. Hot steam may leak out of it.
U-PJT_COMBO-AD_SimpleUX_MANUAL_DC68-04198A-04_EN.indd 21
Softener
Wi-Fi

again to resume the wash cycle.
AI Pattern
Language

to resume operation.
Alarm
Factory Reset

English 21
2022/7/11 9:47:35