Touchpad Click Board - HP 340 G5 Maintenance And Service Manual

Touchpad click board

Table 5-10 Touchpad click board and cables descriptions and part numbers
Description
Touchpad click board
Touchpad board cable
Touchpad click board cable
Before removing the touchpad click board, follow these steps:
1. Prepare the computer for disassembly
2. Remove the rubber feet (see
3. Remove the bottom cover (see
4. Remove the battery (see
To remove the touchpad click board:
1. Disconnect the touchpad cable (1) from the system board ZIF connector, and then disconnect from the
touchpad click board cable (2) from the touchpad ZIF connector.
2. Remove the two Phillips M2.0 × 2.0 screws (3) that secure the touchpad click board to the computer.
3. Lift the board (4), and then slide it outward from under the clips that hold it on place (5).
TIP:
prevent damage to the board or clips.
Reverse this procedure to install the touchpad click board.
40 Chapter 5 Removal and replacement procedures for authorized service provider parts
Computer feet on page
Bottom cover on page
Battery on page
The edge of the board sits under clips. Be sure to slide the board out from under the clips to
(Preparation for disassembly on page
27).
29).
31).
Spare part number
L24486-001
L23184-001
L24485-001
27).