Table of Contents
Advertisement
5
Removal and replacement procedures for
authorized service provider parts
IMPORTANT:
provider. Accessing these parts can damage the computer or void the warranty.
NOTE:
HP continually improves and changes product parts. For complete and current information on
supported parts for your computer, go to http://partsurfer.hp.com, select your country or region, and then
follow the on-screen instructions.
Component replacement procedures
NOTE:
Details about your computer, including model, serial number, product key, and length of warranty,
are on the service tag at the bottom of your computer.
There are as many as 58 screws that must be removed, replaced, or loosened when servicing Authorized
Service Provider only parts. Make special note of each screw size and location during removal and
replacement.
Preparation for disassembly
See
Removal and replacement procedures preliminary requirements on page 21
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
Computer feet
Table 5-1
Computer feel description and part number
Description
Computer feet, natural silver
Computer feet, stone silver
Before removing the computer feet, follow these steps:
▲
Prepare the computer for disassembly
Remove the computer feet:
1.
Close the computer and position it upside down, with the front toward you.
2.
Insert a tool with no sharp edges between the base enclosure and one end of the rubber feet.
Components described in this chapter should only be accessed by an authorized service
(Preparation for disassembly on page
for initial safety procedures.
Spare part number
L24482-001
L56985-001
27).
Component replacement procedures
27
Advertisement
Table of Contents
