Advertisement
Using the Rollover Protection
System (ROPS)
WARNING
There is no rollover protection when the roll bar is
in the down position, and injury or death may result.
• Keep the roll bar in the raised and locked
position and wear the seat belt.
• Lower the roll bar only when absolutely
necessary.
• Do not wear the seat belt when the roll bar is
in the down position.
• Drive slowly and carefully.
• Raise the roll bar as soon as clearance permits.
• Check carefully for overhead clearances (i.e.
branches, doorways, electrical wires) before
driving under any objects and do not contact
them.
Important: Lower the roll bar only when absolutely
necessary.
1. To raise the roll bar, remove the hair pin cotter and
remove the locking pins.
2. Raise the roll bar to the upright position
Important: Always use the seat belt with the roll
bar in the raised position.
3. Install the locking pins. Secure the pins by installing the
hair pin cotter
(Figure
(Figure
G015034
Figure 7
8).
1. Hole in ROPS
2. Locking pin
4. To lower the roll bar, remove the hair pin cotter and
remove the locking pin
5. Lower the roll bar to the down position.
6. Use the two locking and cotter pins to secure the bar.
7).
4
G015035
2
1
2
3
Figure 8
3. Hair pin cotter
(Figure
8).
Advertisement
