Advertisement
the rollbar and verify that the cylindrical spacers are
correctly installed as previously described in
the Rollbar (page
2).
4. If the conical rubber bumpers are not pre-installed
do the following:
Unlock the rollbar and put it in the down
position. Install the conical rubber bumpers inside the
cutout at the top of the rollbar supports as shown in
Figure
6. Secure the bumpers using the flange nuts
(5/16 inch).
1
Figure 6
1. Conical rubber bumper
5. Lock the rollbar in the upright position with the pivot
pins. Use the hairpins at the end of each lanyard to
secure the pivot pins
Important: You must insert the hairpins at the
end of both lanyards into the holes on the straight
end of each pivot pin until they lock in place.
Attaching
2
G017620
2. Flange nut
(Figure
5).
3
Advertisement
