Table of Contents
Advertisement
4.
When installing a new battery, be sure to install metal plates at the locations as shown in the following
illustration. Be sure to install the metal plates on the same side as the battery label.
To replace the battery, reverse the removal procedures.
WLAN module
To remove the WLAN module, use this procedure and illustration.
Table 5-4
WLAN module descriptions and part numbers
Description
WLAN module (MediaTek MT7921 Wi-Fi 6 Bluetooth 5.3 WLAN)
IMPORTANT:
authorized for use in the computer by the governmental agency that regulates wireless devices in your
country or region. If you replace the module and then receive a warning message, remove the module to
restore device functionality, and then contact technical support.
Before removing the WLAN module, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Disconnect the battery cable from the system board (see
Remove the WLAN module:
1.
Remove the Phillips M2.0 × 2.5 screw (1), and then remove the bracket from the module (2).
2.
Carefully disconnect the antenna cables from the module (3).
3.
Pull the module out of the socket to remove it (4).
NOTE:
the appropriate connector on the module.
30
Chapter 5 Removal and replacement procedures for authorized service provider parts
To prevent an unresponsive system, replace the wireless module only with a wireless module
Bottom cover on page
When connecting the antenna cables, be sure to match the number or letter on the cable with
Preparation for disassembly on page
27).
Battery on page
Spare part number
N24438-001
25).
28).
Advertisement
Table of Contents
