Adjusting Trim Angle - Yamaha F40B Owner's Manual

Operation
also affected by variables such as the load in
the boat, sea conditions, and running speed.
EWM00740
WARNING
Excessive trim for the operating condi-
tions (either trim up or trim down) can
cause boat instability and can make
steering the boat more difficult. This in-
creases the possibility of an accident. If
the boat begins to feel unstable or is hard
to steer, slow down and/or readjust the
trim angle.
1. Trim operating angle
EMU27881

Adjusting trim angle

Power trim and tilt models
EWM00750
WARNING
Be sure all people are clear of the out-
G
board motor when adjusting the tilt an-
gle, also be careful not to pinch any
31
1
ZMU04059
body parts between the drive unit and
clamp bracket.
Use caution when trying a trim position
G
for the first time. Increase speed gradu-
ally and watch for any signs of instabil-
ity or control problems. Improper trim
angle can cause loss of control.
Use the power tilt switch located on the
G
bottom engine cowling (if equipped)
only when the boat is at a complete
stop with the engine off.
Adjust the outboard motor trim angle using
the power trim and tilt switch.
1. Power trim and tilt switch
1. Power trim and tilt switch
To raise the bow (trim-out), press the switch
" " (up).
To lower the bow (trim-in), press the switch
UP
DN
1
ZMU04060