Table of Contents
Advertisement
■ Mechanical Disassemblies
Mechanical disassemble should be made following procedures in numerical order.
Following steps show the basic procedures, therefore unnecessary step may be ignored.
Caution:
The parts and screws should be placed exactly the same position as the original otherwise it may cause loss of
performance and product safety.
z
Cabinet Top, FN901 removal
1
A
Remove 5 screws
(M3x8) and pull the Cabinet Top upward off.
A
Lamp Cover SW
* When the cabinet top or lamp cover is removed,
the lamp cover switch is turned off. When turning
on the projector for servicing or adjusting, it is
required to keep turning on the lamp cover switch.
A
A
A
Lamp Cover removal
Insert a coin into a grove of the lamp cover and push the
drive in arrow direction and pull up the lamp cover upward
as shown in the figure below.
* Pay attention not to spoil the cab-
inet by turning the coin or driver.
A
Fig.1-
1
-8-
Screws Expression
(Type
) mm
Diameter x Length
T type
M Type
Fig.1-
2
Advertisement
Table of Contents
