Chevrolet Blazer 2022 Owner's Manual page 38

Chevrolet Blazer Owner Manual (GMNA-Localizing-MidEast-16401983) -
2023 - CRC - 6/17/22
38 Seats and Restraints
3. Start the vehicle with the initial key or
remote key. The DIC welcome message
should display the driver number of the
initial remote key.
Saving Seating Positions
Read these instructions completely before
saving memory positions.
To save preferred driving positions to
1 and 2:
1. Turn the vehicle on or to accessory
mode. A DIC welcome message may
indicate the driver number of the current
remote key. See Identifying Driver
Number previously in this section.
2. Adjust all available memory features to
the desired driving position.
3. Press and release SET; a beep will sound.
4. Immediately upon releasing SET, press
and hold memory button 1 or 2 matching
the current Driver s remote key number
until two beeps sound. If too much time
passes between releasing SET and
pressing 1 or 2, the two beeps will not
sound indicating memory position were
not saved. Repeat Steps 3 and 4 to try
again.
5. Repeat Steps 1 4 for the other remote
key 1 or 2 using the other 1 or 2 memory
button.
It is recommended to save the preferred
driving positions to both 1 and 2 if you are
the only driver.
To save the common exit seating position to
that is used by all drivers for Manually
Recalling Seating Positions and Auto Seat
Exit Memory Recall features, repeat Steps 1
4 using , the exit button.
Manually Recalling Seating Positions
Press and hold 1, 2, or button until the
recall is complete, to recall the positions
previously saved to that button.
Manual Memory recall movement for 1, 2 or
buttons may be initiated and will
complete to the saved memory position if
the vehicle is in or out of P (Park).
Enabling Automatic Recalls
Seat Entry Memory moves the driver seat
to the selected 1 or 2 position when the
vehicle is started. Select Settings > Vehicle
> Seating Position > Seat Entry Memory >
ON or OFF. See Auto Seat Entry Memory
Recall later in this section.
Seat Exit Memory moves the driver seat
to the preferred exit position of the
button when the vehicle is turned off and
the door is opened. Select Settings >
Vehicle > Seating Position > Seat Exit
Memory > ON or OFF. See Auto Seat Exit
Memory Recall later in this section.
Auto Seat Entry Memory Recall
Seat Entry Memory will automatically begin
movement to the seating positions of the 1
or 2 button corresponding to the driver s
remote key number 1 or 2 detected by the
vehicle when:
The vehicle is turned ON.
Seating positions have been previously
saved to the same 1 or 2 button. See
Saving Seating Positions previously in
this section.
Seat Entry Memory is enabled. See
Enabling Automatic Recalls previously in
this section.
The shift lever is in P (Park).
Seat Entry Memory Recall will continue if
the vehicle is shifted out of P (Park) prior to
reaching the saved memory position.