Stop/Start System - Chevrolet Blazer 2022 Owner's Manual

Chevrolet Blazer Owner Manual (GMNA-Localizing-MidEast-16401983) -
2023 - CRC - 6/17/22
186 Driving and Operating
to the floor and holding it there as you
press ENGINE START/STOP, for up to a
maximum of 15 seconds. Wait at least
15 seconds between each try, to allow
the cranking motor to cool down. When
the engine starts, let go of the button
and the accelerator. If the vehicle starts
briefly but then stops again, do the
same thing. This clears the extra gasoline
from the engine. Do not race the engine
immediately after starting it. Operate
the engine and transmission gently until
the oil warms up and lubricates all
moving parts.

Stop/Start System

The Stop/Start system will shut off the
engine to help conserve fuel. It has
components designed for the increased
number of starts.
Warning
The automatic engine Stop/Start feature
causes the engine to shut off while the
vehicle is still on. Do not exit the vehicle
before shifting to P (Park). The vehicle
may restart and move unexpectedly.
Always shift to P (Park), and then turn
the ignition off before exiting the vehicle.
Auto Engine Stop/Start
When the brakes are applied and the vehicle
is at a complete stop, the engine may turn
off. When stopped, the tachometer displays
AUTO STOP. See Tachometer 0 93. When the
brake pedal is released or the accelerator
pedal is pressed, the engine will restart.
To maintain vehicle performance, other
conditions may cause the engine to
automatically restart before the brake pedal
is released.
Auto Stops may not occur and/or auto
restarts may occur because:
The climate control settings require the
engine to be running to cool or heat the
vehicle interior.
The vehicle battery needs to charge.
The vehicle battery has recently been
disconnected.
Minimum vehicle speed has not been
reached since the last Auto Stop
The accelerator pedal is pressed.
The engine or transmission is not at the
required operating temperature.
The outside temperature is not in the
required operating range.
The transmission is shifted out of
D (Drive) to any gear other than P (Park).
Certain driver modes have been selected.
See Driver Mode Control 0 196.
The vehicle is on a steep hill or grade.
The driver door has been opened or driver
seat belt has been unbuckled.
The hood has been opened.
The Auto Stop has reached the maximum
allowed time.
Auto Stop/Start Disable Switch
The automatic engine Stop/Start feature can
be disabled and enabled by pressing
Auto Stop/Start is enabled each time you
start the vehicle.
.