IKEA SKYTTA Installation Manual page 6

Before you start
Marking key measurements
Mark with a line all around the opening where you
are going to place the system. Mark the front of the
system as in the illustration to the right. A crosshair
laser is recommended to use.
Note! From the front of the storage solution to the
front of the track/rails, you need 100 mm for a 2-track
solution and 140 mm for a 3-track solution.
Check if the floor or/and walls are uneven and need
to be adjusted. Measure the width (X1, X2, X3) after
adjustment.
X1 and X3 will be the same if stop bar isn't used.
Measure the height (Y1, Y2, Y3) after adjustment.
_____________ mm
6
X1 X1
_____________ mm _____________ mm
Y1 X1
_____________ mm
X3 X3
_____________ mm _____________ mm
Y2 X1
_____________ mm
X2
_____________ mm
Y3 X1