Daikin DAR09 Service Instructions Manual page 16

Condensing units, split system heat pumps with r-410a refrigerant blowers, coils, & accessories
Table of Contents

Advertisement

PRODUCT IDENTIFICATION
Daikin® BRAND Z-R410A HEAT PUMPS 14 SEER SINGLE STAGE A-BASE UNIT CONDENSERS
Model/Rev
DZ14SA0[18-60]1AA
DZ14SA0381AA
DZ14SA0[18-30]1AB
DZ14SA0[36-42]1AB
DZ14SA0601AB
DZ14SA0[18-60]1AC
DZ14SA0[18-30]1BA
DZ14SA0[18-36]1KA
DZ14SA0[42,49]1KB
DZ14SA0181KB
DZ14SA0[24,30,36,48,60]1KB
DZ14SA0[42,49]1KC
DZ14SA0181KD
DZ14SA0[24,30,36]1KC
DZ14SA0[36,48,60]3AA
DZ14SA0[36,48,60]4AA
DZ14SA0[48,60,36]4AB
DZ14SA0[48,60]1KC
DZ14SA0[48,60]3AB
Daikin® BRAND Z-R410A HEAT PUMPS 14 SEER SINGLE STAGE N-NOMINAL UNITS
Model/Rev
DZ14SN0[18-36]1AA
DZ14SN0601AA
DZ14SN0(24/30)1AB
DZ14SN0181AB
DZ14SN0[42,49]1AB
DZ14SN0[48,60]1AC
DZ14SA
Initial release of models using single speed PSC motors. No low ambient temperature
switch.
Initial release of outdoor model conversion to 35" base with standard flowrator and No
TXV.
Refrigerant quantity reduction.
Reversing Valve change from Dunan to SanHua
Changed indoor unit pairing to achieve a higher HSPF rating. Updated ratings and agency
information.
Initial release of 14 SEER 7mm Non-Inverter Heat Pumps
Motor change on 3 & 3.5T 14 SEER & 2 & 2.5T 16 SEER. Increase blade gap.
Insert Wrap up assembly 0270R01315 back into DZ14SA0181KB heat pump
Refrigerant charge reduction
Refrigerant charge reduction
Equivalent motor with Aluminum Windings replacing Copper Windings.
Initial release of 3PH models using 230V compressors and PSC motors. No CCH switch.
Initial release of 3PH models using 460V compressors and PSC motors. No CCH switch.
Replace Cu motor (22) to Al motor (783) for DZ14SA0484, DZ14SA0604 & Cu motor (23)
to Al motor (784) for DZ14SA0364
Create new Motor 0131M00807 & Replace 0131M00061 with 0131M00807
DZ14SN
Initial release of 14 SEER 7mm Non-Inverter Heat Pumps
Energy Guide Update
New minor revisions on OD units ZP14K6 compressors without hard start kit.
14S 1.5T HPs ONLY.
Motor change on 3 & 3.5T 14 SEER & 2 & 2.5T 16 SEER. Increase blade gap.
Create new Motor 0131M00807 & Replace 0131M00061 with 0131M00807
16
Description
Description
DZ14[SA/SN]

Advertisement

Table of Contents
loading

Table of Contents