Tables - Daikin DAR09 Service Instructions Manual

PRODUCT IDENTIFICATION
Daikin® BRAND X-R410A 13 SEER SINGLE STAGE A-BASE UNIT CONDENSERS
Model/Rev
DX13SA0[18-60]1AA
DX13SA0[18-61]1AB
DX13SA0[36, 48, 60]3AB
DX13SA0[48-60]4AB
DX13SA0611
DX13SA0[42-60]1
DX13SA0[36, 48, 60]3
DX13SA0[48-60]4
DX13SA0[18-24]1AC
DX13SA0[36/48]3AC
DX13SA0[48/60]4AC
DX13SA0364AA
DX13SSA0363AD
DX13SA0361AC
DX13SA0603AC
DX13SA0604AD
DX13SA0484AD
DX13SA0604AE
DX13SA0364AB
DX13SA0[42,48,60,61]1AC
DX13SA0603AD
DX13SA0[18,24,36,42,48,60]1AD
DX13SA0301AC
DX13SA0[18,24]1AE
DX13SA0301AD
DX13SA0361AE
DX13SA0483AD
DX13SA0421AE
DX13SA
Introduction of Daikin 1.5 ton 13 SEER R-410A Condensers conversion to 23" chassis for
the 1.5 - 3 ton models.
One hairpin removed (one hole at the top of the coil and one hole at the bottom of the coil
will remain open). No change in coil circuits.
Introduction of Daikin 13 SEER R-410A Condensers that supplement our current 5 ton
models.
Changed from current four piece louver assembly to a two-piece louver plus a corner post
on 26" and 29" chassis.
Refrigerant quantity reduction.
Introduction of Daikin 13 SEER R-410A 3 Ton with 460V Compressor
Change from copper wound motor to aluminum wound motor
Refrigerant charge reduction
Switching current Daikin units with vertical louvers to be consistent with other units having
horizontal louvers.
Replacing Motor 0131M00022 (Regal) to 0131M00783 (Nidec) where ever used.
Create new Motor & Replace 0131M00023 with 0131M00784
Create new Motor 0131M00807 & Replace 0131M00061 with 0131M00807
Factory Refrigerant Charge Optimization
Replaced motor 0131M000266 with 0131M00811
Replaced motor 0131M00018P with 0131M00813
Change from copper wound compressor motor to aluminum wound compressor motor.
ZP34K5EPFV130 and ZP36K5EPFV130.
10
Description
DX13SA*