Installing The Ceiling Bracket - Hunter Jetty Installation Manual

OFF
Do this first!
WARNING
To avoid possible electrical shock, before
installing your fan, disconnect the power by
turning off the circuit breakers to the outlet
box associated with the wall switch location.
1
Remove all four
mounting isolators.
You have two options for installation. Pick which one works best for your location. Remove any existing
bracket prior to installation. Only use the provided Hunter ceiling bracket that came in your fan's box.
Hunter Pro Tip:
The machine screws are the ones
that came with your outlet box.
Option 1:
Machine Screws
Use machine screws (pro-
vided with outlet box) when
securing to existing ceiling
fan-rated outlet box. Make
sure it is securely installed
and is acceptable for fan
support of 31.8 kg (70 lbs)
or less.
For angled ceilings,
point opening
toward peak.
Ceiling Bracket Downrod
Preparing the Ceiling Bracket
2
Align the tapered mounting holes in the ceiling plate
with the holes in the ceiling bracket. Install the four
ceiling plate screws found in the
secure with the flange nuts using an 9/32" wrench.
Hold the ceiling bracket assembly up to the outlet box
and mark the screw locations. To mount to support
structure, also mark the ceiling for drilling pilot holes.

Installing the Ceiling Bracket

Hanging Fan Wiring
x4
Canopy Plate Screw
x4
bag
Flange Nuts
3
hardware bag and
Option 2:
Wood Screws
Use wood screws (included)
when securing to support
structure with approved
electrical outlet box. Drill
9/64" pilot holes in support
structure to aid in securing
ceiling bracket with
hardware found in the
hardware bag.
Use the wood screw to poke holes
through the rubber gasket in
order to install the ceiling bracket
assembly to your support structure
or ceiling fan-rated outlet box.
Canopy
Install the ceiling plate gasket onto
the ceiling plate. The four holes in
the ceiling plate should lineup with
the four posts in the gasket.
Washer
bag
x2
Wood Screw
Blades Control
1886
x2
4