Invacare HomeFill HF2PCM2KIT Operator's Manual page 20

SECTION 4—INSPECTION AND COMPRESSOR INTERFACE
Cleaning the Cylinder Bag
NOTE: Skip STEP one if the belt is to be cleaned with the cylinder
bag.
1. Unhook and remove the cylinder bag and belt from body.
2. Re-attach the buckle.
NOTE: Either end of the belt can be used in this procedure.
3. Unthread one end of the belt from one side of the buckle.
4. Slide the retaining loop off the belt.
5. Pull the end of the belt that has no buckle and retaining
loop through the two retaining loops on the cylinder bag.
NOTE: The cylinder bag is now removed from the belt.
6. Unhook the tab above the zipper on the cylinder bag.
7. Unzip the cylinder bag.
8. Pull the cylinder bag over the fillport connector and
cylinder gauge.
9. Hand wash the cylinder bag with mild detergent and let
air dry.
10. Ensure the cylinder bag is dry.
11. Insert the cylinder into the cylinder bag.
NOTE: The fillport connector uses the circular cutout closest to the
zipper and the cylinder gauge uses the remaining circular cutout.
12. Close the zipper and the tab above the zipper to secure the
cylinder.
13. Install the cylinder bag onto the belt starting with Step 6 of
Changing the Carrying Position of the Cylinder on
page 18.
Oxygen Conserving Cylinder 20 Part No 1143247