Important Notice 1:(Other Than U.s.a. And Canadian Market); How To Define The Model Suffix (Ntsc Or Pal Model) - Panasonic Lumix DMC-FZ10PP Service Manual

iron with temperature control, please set it to 700±20°F (370±10°C)
- Pb free solder will tend to splash when heated too high (about
1100°F/600°C).
When soldering or unsoldering, please completely remove all of the solder on the pins or solder
area, and be sure to heat the soldering points with the Pb free solder until it melts enough.
1.3. IMPORTANT NOTICE 1: (Other than U.S.A. and Canadian Market)
1. The service manual does not contain the following information,
because of the impossibility of servicing at component level.
A. Schematic diagram, Block Diagram and C.B.A. layout of Main
C.B.A.
B. Parts list for individual parts of Main C.B.A.
When a part replacement is required for repairing Main C.B.A.,
replace as an assembled parts. (Main C.B.A.)
2. The following category is/are recycle module part. please send it/
them to Central Repair Center.
- MAIN C.B.A. (VEP56009A) : Excluding replacement of Lithium
Battery

1.4. HOW TO DEFINE THE MODEL SUFFIX (NTSC or PAL model)

There are four kinds of DMC-FZ10, regardless the colours.
- a) DMC-FZ10S
- b) DMC-FZ10PP
- c) DMC-FZ10EB/EG/GC/GN/SG
- d) DMC-FZ10PL/GD
(DMC-FZ10S is exclusively Japan domestic model.)
What is the difference is that the "INITIAL SETTING" data which is stored in Flash ROM
mounted on Main C.B.A.
1.4.1. Defining methods:
To define the model suffix to be serviced, refer to the nameplate which is putted on the bottom
side of the Unit.
3