Figure 9: Set Temporary Ip Address - Emerson PACSystems RX3i User Manual

PACSystems™ RX3i and RSTi-EP CPU Reference Manual
GFK-2222AK
▪
Note: To set the IP address, you will need the MAC address of
the Ethernet Interface to which PME will be connected.
1. Connect the PACSystems CPU LAN to the Ethernet network
on which PME is communicating.
2. In the Project tab of the Navigator, right click the
PACSystems target, choose Offline Commands, and then
choose Set Temporary IP Address. The Set Temporary IP
Address dialog box (Figure
3. In the Set Temporary IP Address dialog box, do the
following:
Key in the 12-digit hexadecimal MAC address (two
▪
digits per field).
In the IP Address to Set box, specify the temporary IP
▪
address you want to set for the PACSystems LAN.
If necessary, select the Enable Network Interface
▪
Selections check box and specify the IP address of the
network interface on which the PACSystems is located.
4. When the fields are properly configured, click the Set IP
button.
5. The IP Address of the specified PACSystems LAN will be set
to the specified temporary address. This may take up to a
minute.
After the programmer connects over Ethernet, the permanent IP address for the Ethernet
interface, which is set in the hardware configuration, will have been downloaded to the
CPU.
The temporary IP address remains in effect until the Ethernet interface is restarted,
power-cycled or until the hardware configuration is downloaded or cleared.
CPU Configuration
The target PACSystems must be located on the same local sub-network as the
computer running the Set Temporary IP Address utility. The sub-network is specified
by the computer's subnet mask and the IP addresses of the computer and the
PACSystems Ethernet Interface.
9) appears.

Figure 9: Set Temporary IP Address

Section 3
October 2019
74