Chevrolet Silverado EV 2024 Instruction Manual page 378

5. Turn the three bolts three quarter turn
counter-clockwise and remove the left
side access cover.
6. Locate the battery positive (+) terminal
and negative ( ) grounding point.
7. Check that the jumper cables do not
have loose or missing insulation. If they
do, you could get a shock. The vehicles
could be damaged too.
8. Connect one end of the red positive (+)
cable to the discharged battery
positive (+) terminal.
Do not let the other end touch metal.
9. Connect the other end of the red
positive (+) cable to the good battery
positive (+) terminal.
10. Connect one end of the black negative
( ) cable to the good battery negative
( ) terminal.
Do not let the other end touch anything
until the next step.
11. Connect the other end of the negative
( ) cable to the discharged battery
negative ( ) grounding point.
12. Now start the vehicle with the good
battery and keep the vehicle running for
a while.
13. Try to start the vehicle that had the
dead battery. If it will not start after a
few tries, it probably needs service.
Vehicle Care
Caution
If the jumper cables are connected or
removed in the wrong order, electrical
shorting may occur and damage the
vehicle. The repairs would not be covered
by the vehicle warranty. Always connect
and remove the jumper cables in the
correct order, making sure that the cables
do not touch each other or other metal.
Jumper Cable Removal
Reverse the sequence exactly when
removing the jumper cables.
After starting the disabled vehicle and
removing the jumper cables, allow it to idle
for several minutes.
After removing the jumper cables, install the
left side access cover by turning the three
bolts three quarters clockwise.
377