Chevrolet Silverado EV 2024 Instruction Manual page 220

: Press to disengage ACC without erasing
the selected set speed. Press and hold to
switch between ACC and regular cruise
control. See Switching Between ACC and
Regular Cruise Control later in this section.
: Press to cycle through the three
following gap settings for ACC: Far, Medium,
or Near. See Selecting the Follow Distance
Gap later in this section.
The speedometer reading can be displayed
in either English or metric units. See Settings
0 166. The increment value used depends on
the units displayed.
Switching Between ACC and Regular Cruise
Control
To switch between ACC and regular cruise
control, press and hold . A message is
briefly displayed in the Driver Information
Center (DIC). See Vehicle Messages 0 135.
ACC Indicator Regular Cruise Control
Indicator
When ACC is the selected cruise control
mode and is activated, a green
indicator light is displayed in the instrument
cluster and the following gap is displayed.
When regular cruise control is the selected
cruise control mode and is activated, a green
cruise control indicator light is displayed
in the instrument cluster, however the
following gap is not displayed.
When the vehicle is turned on, the cruise
control mode will be set to the last mode
used before the vehicle was turned off.
Warning
Always check the cruise control indicator
on the instrument cluster to determine
which mode cruise control is in before
using the feature. If ACC is not active, the
vehicle will not automatically brake for
other vehicles, which could cause a crash
if the brakes are not applied manually.
You and others could be seriously injured
or killed.
Driving and Operating
Setting Adaptive Cruise Control
ACC
If ACC is on but not engaged, the
thumbwheel could be pressed to SET or
+RES and engage ACC when not desired.
Keep ACC off when it is not being used.
Press to turn off ACC.
The set speed is the vehicle speed when
another vehicle is not detected in your path.
ACC cannot be set below the minimum
allowable cruise speed. For vehicles that are
not equipped with Super Cruise, the
minimum allowable ACC cruise speed is
25 km/h (15 mph). For vehicles equipped with
Super Cruise, the minimum allowable ACC
cruise speed is 5 km/h (3 mph).
To set the ACC cruise speed while moving:
1. Press
.
2. Accelerate to the desired speed.
3. Briefly press the thumbwheel down to
SET and release it.
4. Gently remove your foot from the
accelerator pedal.
After the ACC cruise speed is set, ACC may
immediately apply the brakes if it detects a
vehicle ahead that is closer than the
selected following gap.
219