Auto Guidance; Setting And Following An Auto Guidance Path; Creating And Saving An Auto Guidance Path; Adjusting An Auto Guidance Path - Garmin ECHOMAP UHD Owner's Manual

Auto Guidance

The Auto Guidance feature is based on electronic chart information. That data does not ensure obstacle and
bottom clearance. Carefully compare the course to all visual sightings, and avoid any land, shallow water, or
other obstacles that may be in your path.
All route and navigation lines displayed on the chartplotter are only intended to provide general route guidance
or to identify proper channels, and are not intended to be precisely followed. Always defer to the navaids and
conditions on the water when navigating to avoid groundings or hazards that could result in vessel damage,
personal injury, or death.
NOTE: Auto Guidance is available with premium charts, in some areas.
You can use Auto Guidance to plot the best path to your destination. Auto Guidance uses your chartplotter to
scan chart data, such as water depth and known obstacles, to calculate a suggested path. You can adjust the
path during navigation.

Setting and Following an Auto Guidance Path

1 Select a destination (Destinations,
2 Select Navigate To > Auto Guidance.
3 Review the path, indicated by the magenta line.
4 Select Start Navigation.
5 Follow the magenta line, steering to avoid land, shallow water, and other obstacles
page 31).
NOTE: When using Auto Guidance, a gray segment within any part of the magenta line indicates that Auto
Guidance cannot calculate part of the Auto Guidance line. This is due to the settings for minimum safe water
depth and minimum safe obstacle height.

Creating and Saving an Auto Guidance Path

1 Select Nav Info > Routes > New Route > Auto Guidance.
2 Select a starting point, and select Next.
3 Select a destination, and select Next.
4 Select an option:
• To view a hazard and adjust the path near a hazard, select Hazard Review.
• To adjust the path, select Adjust Path, and follow the on-screen instructions.
• To delete the path, select Delete.
• To save the path, select Done.

Adjusting an Auto Guidance Path

1 Select Nav Info > Routes.
2 Select a path, and select Edit > Adjust Path.
TIP: When navigating an Auto Guidance path, select the path on the navigation chart, and select Adjust Path.
3 Select a location on the path.
4 Select an option:
• On device with keys, use the arrow keys.
• On device with touchscreens, drag the path.
5 If necessary, select a point, and select Remove.
6 Select Done.
Navigation with a Chartplotter
WARNING
page 32).
(Route Color Coding,
37