JVC JY-HD10EK Instructions Manual page 36

36
EN
Wide mode
DV WIDE
OFF: Records with no change in the screen ratio.
For playback on a TV with a normal screen ratio.
16:9SQ* : For playback on TVs with an aspect
ratio of 16:9. Naturally expands the image to fit
the screen without distortion. The
appears. When using this mode, refer to your
wide-screen TV's instruction manual. During
playback/recording on 4:3 TVs/LCD monitor/
viewfinder, the image is elongated vertically.
D.WIDE* : The
zoom range is extended beyond the maximum
optical zoom wide angle range. This mode's wide
angle setting is equivalent to using a 0.7X wide
conversion lens. Zooming is possible from 0.7X to
a magnification set in CAMERA Menu. This mode
is suitable for shooting in a small room.
* Not available when the Recording Mode Switch
is set to "HD" or "MEMORY".
Wind cut
WIND CUT
OFF: Disengages the function.
ON : Helps cut down on noise created by
wind. The " " indicator appears. The quality of
the sound will change. This is normal.
Colour bar
COLOR BAR
OFF: Colour bars do not appear.
ON: Colour bars appear on screen which allows
colour settings to be adjusted quickly and easily
for natural-looking picture reproduction. Colour
bars are recorded in the image by shooting with
the setting to "ON".
(Factory-preset: OFF)
indicator
indicator appears. The
(Factory-preset: OFF)
(Factory-preset: OFF)
RECORDING MENUS (cont.)
System Menu
SYSTEM
Beep, melody and shutter sound
BEEP
OFF: Even though not heard while shooting,
shutter sound is recorded on the tape.
BEEP: The beep sounds when the power is turned
on or off, and at the beginning and end of
recording. It also activates the shutter sound
effect. ( pg. 26, 42)
MELODY: Instead of a beep, a melody sounds
when any operation is performed. It also activates
the shutter sound effect. (
Tally lamp setting
TALLY
OFF: The tally lamp remains off at all times.
ON: The tally lamp comes on to signal the start of
recording.
Remote control setting
For details, refer to "USING THE REMOTE
CONTROL UNIT" (
REMOTE
OFF: Disables the remote control operations.
ON: Enables the remote control operations.
Priority setting
When the viewfinder is pulled out while the LCD
monitor is opened, you can select which one to use.
PRIORITY
LCD: Allows you to use the LCD monitor.
FINDER: Allows you to use the viewfinder.
BOTH: Allows you to use both the LCD and
viewfinder.
(Factory-preset: OFF)
pg. 26, 42)
(Factory-preset: ON)
pg. 56).
(Factory-preset: ON)
(Factory-preset: LCD)