Philips BJ3.1E LA Service Manual page 29

Service Modes, Error Codes, and Fault Finding BJ3.1E LA 5. EN 29
Semi Stand by
action holder: MIPS
action holder: St-by
autonomous action
Reboot
Power-down HDMI and 1394 hardware by keeping
POWERDOWN-1394 GPIO 0 line high.
Set Viper HW blocks (TM1, TM2, MBS, VMSP1 and
VMSP2) to powerdown mode.
Hibernate the PNX2015 memory and keep the
PNX2015 in reset state
Disable +8V6 supply detection algorithm
Disable audio protection algorithm
Switch OFF all supplies which are not needed in POD
standby by switching HIGH the ON-MODE I/O line.
POD standby
G_15960_134.eps
011206
Figure 5-12 "Semi Stand-by" to "POD Stand-by" flowchart