Philips BJ3.1E LA Service Manual page 21

Service Modes, Error Codes, and Fault Finding
are fixed. So for a customer location must be set to "Home".
Can be changed via the installation menu (see also DFU).
• HDMI key validity. Indicates if the HDMI keys (or HDCP
keys) are valid or not. In case these keys are not valid and
the customer wants to make use of the HDMI functionality,
the SSB has to be replaced.
• IEEE key validity. Not applicable.
• POD key validity. Not applicable.
• Tuner Frequency. Indicates the frequency the selected
transmitter is tuned to.
• TV System. Gives information about the video system of
the selected transmitter. In case a DVBT signal is received
this item will also show ATSC.
– BG: PAL BG signal received
– DK: PAL DK signal received
– L/La: SECAM L/La signal received
– I: PAL I signal received
– M: NTSC M signal received
– ATSC: ATSC or DVBT signal received
• Source. Indicates which source is used and the video
quality of the selected source. (Example: Tuner, Video)
Source: "TUNER", "EXT1", "EXT2", "EXT3", "EXT4",
"YPbPr1", "YPbPr2", "VGA", "DVI-I", ""HDMI 1", "HDMI 2",
"SIDE" and "DVI". Video signal quality: "VIDEO", "S-
VIDEO", "RGB 1FH", "YUV", "VGA", "SVGA", "XGA",
"CVBS", Y/C", "YPBPR 1FH 480p", "YPBPR 1FH 576p",
"YPBPR 1FH 1080I", "YPBPR 2FH 480p", "YPBPR 2FH
576p", "YPBPR 2FH 1080i", "RGB 2FH 480p", "RGB 2FH
576p", "RGB 2FH 1080i", "720p" or "Unsupported".
• Tuned Bit. Due to the DVBT architectural setup this item
does not give useful information any more.
• Digital signal modulation. No useful information for
Service purposes.
• 12NC one zip SW. Displays the 12NC number of the one-
zip file as it is used for programming software in production.
In this one-zip file all below software version can be found.
• Initial main SW. Displays the main software version which
was initially loaded by the factory.
• Current main SW. Displays the built-in main software
version. In case of field problems related to software,
software can be upgraded. As this software is consumer
upgradeable, it will also be published on the Internet.
Example: BX31E_1.2.3.4.
• Flash utils SW. Displays the software version of the
software which contains all necessary components of the
download application. To program this software, EJTAG
tooling is needed. Example: FLASH_1.1.0.0.
• Standby SW. Displays the built-in stand-by processor
software version. Upgrading this software will be possible
via ComPair or via USB.(see chapter Software upgrade).
Example: STDBY_3.0.1.2.
• MOP SW. Not applicable for this chassis.
• Pacific 3 Flash SW. Displays the Pacific 3 software
version.
• NVM version. Displays the NVM version as programmed
by factory.
How to Exit CSM
Press "MENU" on the RC-transmitter.
BJ3.1E LA 5. EN 21