Operator Training - Fetco CBS-2231 Users Manual And Operator Instructions

Operator Training

Review the operating procedures with whoever will be using the brewer.
Pay particular attention to the following areas:
Always pre-heat the dispensers before the first use of each day by filling them halfway with hot water and letting them stand for at
least 5 minutes.
Do not remove the brew basket from a coffee brewer until it has stopped dripping.
Make sure the dispenser is empty before brewing into it.
Show how to attach covers, close, and or secure the dispensers for transporting.
Show the location and operation of the water shut off valve as well as the circuit breaker for the brewer.
Steam from the tank will form condensation in the vent tubes. This condensation will drip into and then out of the brew baskets.
Up to 1/4 cup/118cc discharging overnight is possible. Place an appropriate container under each brew basket when not in use.
We recommend leaving the power to the brewer on overnight. The water tank is well insulated and very little electricity is used to
keep the tank hot. Leaving the brewer in the "ON" position will also avoid delays at the beginning of shifts for the brewer to reach
operating temperature.
Cleaning & Maintenance
After Each Brew:
Dispose of grounds and rinse brew basket.
Never strike a brew basket or hit it against a hard surface.
This will damage the brew cone, and may damage the brew basket support rails
Rinse dispensers before reuse.
Every Day:
Wash brew basket with hot sudsy water.
Pull CSD from the spray head, it is magnetically attached. Use gloves or a heavy towel. 
Wash off any film and reattach. Use vinegar if limescale filming is present.
Clean dispensers with hot suds water and a brush, rinse and air dry.
Use only a soft cloth and hot suds on the outside to avoid scratches. Never use abrasives that will scratch surface.
Weekly
Use a commercial coffee dispenser cleaner such as URNEX™, TABZ™, DIP-IT™ or Squeak 'n Clean™.
Carefully Follow the instructions supplied with the cleaning product
Never use spray cleaners, solvent, solvent based cleaner or petroleum based polish anywhere on dispensers
Warning
Turn off power before any cleaning procedure, including wiping the exterior for appearance reasons.
Dry the exterior, especially the face panel, before turning on power.
Do not apply any type of spray cleaner on the face panel of this equipment.
Never use solvent or solvent-based cleaner or petroleum based polish anywhere on this equipment.
Dry the face of the touch pad before turning on power
Do not electrically energize this equipment or attempt operation without all covers in place and all screws fastened.
Unplug machine before disassembly or servicing.
Safety Notes
Professional installation is required. This appliance is manufactured only for commercial use
Operational requirements and maintenance for commercial cooking appliances differ from household appliances.
Operators must be trained for this equipment and must understand the use, maintenance and hazards.
Access to the service area is restricted to persons having safety/hygiene knowledge and practical experience of the coffee brewer. This
appliance must be installed in locations where it can be overseen by adult trained personnel.
Do not attempt to move hot beverage equipment once it is filled. Drain equipment before moving.
FETCO commercial coffee brewers prepare large amounts of coffee or tea in a single batch using very hot water
Commercial coffee brewers provide very hot water from the spray head, brew basket and faucet when it is pulled.
Coffee brewers may continue to dispense very hot water from the mechanically operated faucet after the electronic touchpad is
completely disabled by turning off the power switch on the lower back of the unit or unplugging the unit.
For safety, the brewer control locks the brew basket for 6.0 minutes after starting the brew.
Never attempt to defeat the factory set (default) time that the brew basket is locked for safety from start of brew.
Keep these instructions for training and future reference.
15 P215 REV000 February 2023