Atuc-Ira - Audio Technica ATUC-M58H Instruction Manual

Digital wired conference system, gooseneck microphone with led ring, discussion unit, interpretation unit, control unit, integration unit, link extender, voting unit, ir discussion unit, hybrid control unit, hybrid control unit dante-enabled, ir transmitt
Hide thumbs Also See for ATUC-M58H:
Table of Contents

Advertisement

Symptom
Initialization operation does not end
(LEDs continue flashing).
The
(talk) button does not function.
The sound from the connected
microphone is distorted or cannot be
heard.
No sound is output from the
headphone jack.
No sound is output from the built-in
speaker.
ATUC‑IRA
Symptom
Cannot turn on the power to ATUC-
IRA.
Check the installation locations of the IRDUs and IRAs.
There may be a limit on the number of IRDUs that are detected at system start.
Check the infrared setting again.
[Settings & Maintenance] → [System Settings] → [Infrared]
If this is the case, connection is possible by operating any button on the IRDU.
Depending on the conference mode or settings, the
function. Check the conference mode settings.
To check from Web Remote:
[Settings & Maintenance] → [Install Settings] → [Conference] → [Conference Mode]
To check on the CU display:
Set → Log in as Administrator or Operator → Conference Mode
Check the installation locations of the IRDUs and IRAs.
Check the ID settings of the device.
There may be interference with the infrared. The problem may be solved by the
settings for the infrared frequency that you are using.
[Settings & Maintenance] → [System Settings] → [Infrared] → [IRDU Band]
Insert the headphone plug securely all the way in.
Raise the volume with the + button on the IRDU.
Use the monitor channel selection button(s) to confirm that you can monitor speech
from the channel you want.
From [Settings & Maintenance] → [Install Settings] → [DU/IU] → [DU/IU Detail
Settings], check that the [Speaker] setting is set to [Enabled].
Adjust the speaker level.
To check from Web Remote:
[Settings & Maintenance] → [Install Settings] → [DU/IU] → [Global DU/IU Settings]
→ [Speaker Level]
To check on the CU display:
Set → Log in as Administrator or Operator → Audio Setting → DU SP Output Lvl
Check the connections of the cables.
Check that the cables are not damaged.
67
Cause/Solution
(talk) button may not
Cause/Solution
Page
-
page 55
page 10
-
page 58
page 55
page 46
page 46
page 46
page 28
page 10
Page
page 57

Advertisement

Table of Contents
loading

Table of Contents