NOTICE
• For any DUs that were not assigned an ID, such as due to
poor infrared transmissions, turn off their power, and
then, while pressing on the "<"/">" monitor channel
selection buttons, turn on the power and perform "Auto
Setting" or "Manual Setting" to specify the ID.
M anual settings:
① While pressing the "<"/">" monitor channel selection
buttons, press the power switch.
② Look at the display to input the ID number you want.
<Example: To set ID number "152">
1 W hile pressing the "<"/">" monitor channel selection buttons,
press the power switch.
2 Press the "<"/">" buttons so the 2 appears as the first digit.
3 Press the left multifunction button to set the second digit.
4 Press the "<"/">" buttons so the 5 appears as the second digit.
5 Press the left multifunction button to set the third digit.
6 Press the "<"/">" buttons so the 1 appears as the third digit.
7 Press the right multifunction button to apply the setting.
(After step 7, you can use the system in regular modes.)
Additional procedures closely follow the procedures for the ATUC-
50 system. Refer to " 4 Connecting an amplifier" (
" Wired System Connections and Configuration".
➤
page 38) in
59