Gigabyte GA-F2A88X-UP4 User Manual page 61

The selection bar will move to the Disks section on the right of the screen. Select the hard drives to be included
in the RAID array. Use the up or down arrow key to select a hard drive and press <Insert>. The selected hard
drive will be shown in green. To use all of the hard drives, simply press <A> to select all. Then press <Enter>
and the selection bar will move to the User Input section on the left bottom of the screen. (Figure 10)
RAID0: Stripe set - distributes space across disks for higher performance
Arrays
Create Array
Disks: 0, 1
Type: RAID 0
User Input
Select Array Type to Create
RAID5 RAID10N
RAID0 RAID1N
RAID1 Volume
RAID10 RAIDABLE
RAID50
First, select a RAID mode and press <Enter>. The selections available depend on the number of the hard drives
being installed. Then follow the on-screen instructions to specify the array size. You can select All available
space to use the maximum size allowed or use the up or down arrow key to adjust the size (Figure 11) and
press <Enter>.
Arrays
Create Array
Disks: 0, 1
Type: RAID 0
Total Size: 158GB
User Input
Choose Size to Make Array
Size Chosen: All available space
DOS Size: 147GB
Exactly: 158, 892, 818, 432
AMD-RAID Array Configuration (Build: 6.1.1-00075)
0-00, 79GB, Ready
1-01, 79GB, Ready
<h><i><f><g>=Choose, <Esc>=Back
<Enter>=Select Menu Item
Figure 10
AMD-RAID Array Configuration (Build: 6.1.1-00075)
0-00, 79GB, Ready
1-01, 79GB, Ready
<PAGEUP><h><PAGEDOWN><i>=Change Size
<Enter>=Complete, <Esc>=Go Back
Figure 11
- 61 -
Disks
Available Keys
Disks
Available Keys
Configuring SATA Hard Drive(s)