Gigabyte GA-F2A88X-UP4 User Manual page 56

B. Configuring SATA controller mode in BIOS Setup
Make sure to configure the SATA controller mode correctly in system BIOS Setup.
Step 1:
Turn on your computer and press <Delete> to enter BIOS Setup during the POST (Power-On Self-Test). Make
sure OnChip SATA Channel is enabled. To enable RAID for the SATA3 0/1/2/3 connectors, set OnChip SATA
Type to RAID. To enable RAID for the SATA3 4~SATA3 6 and eSATA connectors, set OnChip SATA Type to
RAID and set OnChip SATA Port4-7 Type to As SATA Type (Figure 1).
Step 2:
If you want to configure UEFI RAID, follow the steps in "C-1." To enter the legacy RAID ROM, save the settings
and exit BIOS Setup. Refer to "C-2" for more information.
The BIOS Setup menus described in this section may differ from the exact settings for your motherboard.
The actual BIOS Setup menu options you will see shall depend on the motherboard you have and
the BIOS version.
Configuring SATA Hard Drive(s)
Figure 1
- 56 -