Table of Contents
Advertisement
The ProSense detection is
carried out with complete
washing programmes only
(no skipping phase
selected).
10.13 Opening the door when
the programme operates
CAUTION!
If the temperature and level
of the water in the drum are
too high, the door lock
indicator
you cannot open the door.
To open the door proceed as follows:
1. Press the button On/Off for some
seconds to deactivate the appliance.
2. Wait for some minutes and then
open carefully the appliance door.
3. Close the appliance door.
4. Activate the appliance and set the
programme again.
10.14 Opening the door when
the delay start is active
While the delay start operates, the
appliance door is locked.
To open the appliance door:
1. Press button Inicio/Pausa.
In the display the door lock indicator
goes off.
2. Open the appliance door.
3. Close the door and press button
Inicio/Pausa.
The delay start continues.
10.15 End of cycle
When the programme has finished, the
appliance stops automatically. The
acoustic signal operates (if it is active).
In the display
comes on and the lid
locked indicator
The indicator of Inicio/Pausa button goes
off.
1. Press button On/Off to deactivate
the appliance.
stays on and
goes off.
After five minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
When you activate the
appliance again, the display
show the end of the last set
programme. Turn the
programme knob to set a
new cycle.
2. Remove the laundry from the
appliance.
3. Make sure that the drum is empty.
4. Keep the door ajar, to prevent
mildew and odours
10.16 Draining water out after
end of cycle
The washing programme is completed,
but there is water in the drum:
The drum turns regularly to prevent the
creases in the laundry.
The lid lock indicator
stays locked.
You must drain the water to open the lid:
1. If necessary, decrease the spin
speed.
2. Press the Inicio/Pausa button.
The appliance drains the water and
spins.
3. When the programme is completed
and the door lock indicator
off, you can open the door .
4. Press On/Off some seconds to
deactivate the appliance.
The appliance drains and
spins automatically after
approximately18 hours.
10.17 AUTO Stand-by option
The AUTO Stand-by function
automatically deactivates the appliance
to decrease the energy consumption
when:
• You do not use the appliance for 5
minutes before you press Inicio/Pausa
button.
Press the button On/Off to activate
the appliance again.
• After 5 minutes from the end of the
washing programme
ENGLISH
21
is on. The lid
goes
Advertisement
Table of Contents
